In 1997, northern France buried 31.2 tons of incinerator ash beneath a test road; 10 years later, copper, lead, and zinc had fallen to natural road levels

A comprehensive study conducted in northern France explored the application of incinerator bottom ash in road construction. With 31.2 tons of ash integrated beneath a test road, researchers monitored its stability and metal leaching over a decade....

An AI-generated representative image of a road cross-section represents the French field experiment that tested whether incinerator bottom ash could safely be used beneath road surfaces over the long term. (Image credit: ChatGPT)

In northern France, a small road became a place for a decade-long environmental experiment for researchers. In 1997, they buried 31.2 tons of municipal solid waste incinerator bottom ash under a test road to see if it would be stable when used in construction. The question was not only whether the ash could support a road but whether metals trapped inside the waste material could slowly escape into the surrounding environment. By monitoring the roadway for ten years, the researchers established that the concentration of the three metals detected in water flowing through the ash layer was similar to that of traditional roadways made of natural materials. The research article published in the Journal of Hazardous Materials provides insights into changes in the ash layer over ten years.

The motivation for this experiment arose from the need for cities to solve the issue of managing the increasing amount of ash following waste incineration. Although incinerator bottom ash includes materials that can be recycled, it also sometimes contains metals whose presence is considered environmentally harmful. Therefore, to check whether such materials would be able to migrate out of this kind of construction, the authors required long-term field tests.

A road built to test waste ash


Rather than researching the ash in a laboratory, a test road was created in northern France. The road was constructed with a 25 cm subbase layer comprising a mixture of incinerator bottom ash, which was a suitable material for the road, and other materials, to provide a realistic test environment for assessing the performance of the mixture over time, due to the influence of rain, temperature changes, and vehicle traffic. A comparison section was also constructed with natural limestone material. Both sections were studied under similar conditions to compare the amount of metals released from the ash-based road to a traditional road structure. The materials used for the production of the ash were those obtained in municipal solid waste incineration plants. It was treated and prepared for this use as a construction material before being placed under the roadway. The researchers then started to monitor changes in the material, not just its initial condition.

What rainwater revealed about the ash

The road was not the issue; its condition in the presence of water was the issue. During construction, the rainwater can also absorb dissolved components, which may result in the release of metals to the environment. Water that flows through the road materials, known as leachate, was collected and studied to gain an understanding of it. They determined the levels of various elements, including copper, lead, and zinc, which may indicate the existence of potentially harmful substances being released from the waste products. The preliminary tests indicated that the amount of some metals in the ash was greater than that in the natural road material. Those levels, however, did change as the ash lay beneath the ground’s surface and came into contact with the environment.
ADVERTISEMENT

How the ash changed underground

The long-term monitoring showed that the ash behavior over time did not match that when it was first deposited under the road. As the years passed, the copper, lead, and zinc content decreased. The concentrations in the leachate from the ash-based road section after 10 years were approximately the same as the concentrations seen in the natural limestone comparison section. Chemical reactions that took place within the ash with age were correlated with this change, with certain reactions changing the manner in which metals were bound into the ash. These results were inconclusive that all incinerator ash could be used in roads. Instead, the study found that long-term testing is required due to the fact that properties of waste materials can vary greatly over time after they are underground.

Why time became the biggest factor

The northern France test road also allowed researchers to study how a waste-derived material ages after being placed inside a construction structure. In situations where laboratory samples can only recreate certain conditions for a short time period, the experiment that took place on the actual road enabled scientists to see changes that happened to the large volume of ash in natural weather conditions. The results of this study were used to broaden research on the use of incinerator bottom ash in engineering projects. The research showed that the decision-making process related to the use of the materials composed of waste depends not only on the initial characteristics of these materials, but also on their changes that took place in the course of years.
Download
The Economic Times Business News App
for the Latest News in Business, Sensex, Stock Market Updates & More.
Download
The Economic Times News App
for Quarterly Results, Latest News in ITR, Business, Share Market, Live Sensex News & More.
READ MORE
ADVERTISEMENT

READ MORE:

LOGIN & CLAIM

50 TIMESPOINTS

More from our Partners

Loading next story
Business News › News › International › US News › In 1997, northern France buried 31.2 tons of incinerator ash beneath a test road; 10 years later, copper, lead, and zinc had fallen to natural road levels
Text Size:AAA
Success
This article has been saved

*

+